Run dhcp configuration wizard windows 2008

Feedback will be sent to Microsoft: By pressing the submit button, your feedback will be used to improve Microsoft products and services. Privacy policy. Before you configure the DHCP service, you must install it on the server. You can install DHCP during the initial installation of Windows Server , or after the initial installation is completed.

After you have installed the DHCP service and started it, you must create a scope. Microsoft recommends that, each DHCP server in your environment has at least one scope that does not overlap with any other DHCP server scope in your environment. Small Business Server.

Read Sticky Post at the top of the forum. Sign in to vote. Thanks, Rob Battaglia. Thursday, April 14, PM. Are you certain DHCP is disabled on the router? It needs to be. Rob Williams. You say that you have created a new scope. Have you authorised the scope? If you haven't it will have a little red icon next to it, and the server will not respond to client requests. If you have it will be green and everything should be fine.

Alan Moseley. If DHCP on the linksys was running during setup, then this is the cause for your issues. Run the fix my network wizard, then the connect to internet wizard.

Since I only have one network card and I am not using this network on the internet I can't run the connect to the internet wizard. I currently do not have IPV6 configured. Do you have any good articles on setting up IPV6? Additionally, you will want to have a plan for all subnets involved, what scopes you will want to define, and what exclusions you will want to create.

Figure 1: Adding a new Role in Windows Server At this point, you will begin being prompted for IP network information, scope information, and DNS information. If you only want to install DHCP server with no configured scopes or settings, you can just click Next through these questions and proceed with the installation. On the other hand, you can optionally configure your DHCP Server during this part of the installation.

Figure 3: Network connection binding. Figure 4: Entering domain and DNS information. I have opted to configure an IP address range of To do this, I clicked Add to add a new scope.

Figure 6: Confirm Installation Selections. Thus, this is a good place to go to check the status of the DHCP Server and what events have happened around it. If I go into the address pool and the scope options, I can see that the configuration we made when we installed the DHCP Server did, indeed, work.